nightdrew
25/09/2008, 11:40
Vendo amplificador integrado PLINIUS 9200 balanceado. Phono, con toda su documentación y embalaje oríginal, y mando a distáncia. Junto a él , dos Dynaudio Contour 3.4 color Rosewood,tambien con sus embalajes originales. El equipo se compró en Marzo del 2007. Está absolutamente impecable y funcionando. Si soys de Barcelona , ningún problema en oirlo y probarlo, sinó puedo mandar fotos aunque ya digo ,mejor oir!!.
El cambio se debe a que la sala de escuha ha aumentado a mas del doble..
Precio: 4800 euros Todo. Posibilidad de venderlo separado.
Saludos
Adjunto las caracteristicas del ampli :
Power: 200 watts per channel into 8 Ohms. Both channels driven from 20Hz to 20kHz at less than 0.2% total harmonic distortion
Frequency Response: 20Hz to 20kHz ±0.2dB, -3dB at 5Hz and -3dB at 70kHz
Distortion: Typically <0.05% THD at rated power 0.2% THD and IM worst case prior to clipping
Current Output: 40A short duration peak per channel. Fuse protected
Slewing: 50V/µs
Hum & Noise: 90dB below rated ouput 20Hz to 20kHz unweighted
Gain: Line inputs to speaker out: 40dB
Phono Input To Pre-Out: 66dB on high gain, 60dB on low gain
Input Impedance: 47kOhms all inputs
Input Overload: 5V RMS
Rated Pre Out Level: 1.5V RMS into 47kOhms or higher
Pre Out Source Impedance: Typically 1.5k Ohms
Pre Out Minimum Recommended Load: 47kOhms
Tape Output Level: 190mV at 200 Ohms. Tape loop muting at 5V RMS input
Dimensions: Height 120mm (4.75"), Width 450mm (17.75"), Depth 400mm (15.75"), Weight 14kg (30lbs)
El cambio se debe a que la sala de escuha ha aumentado a mas del doble..
Precio: 4800 euros Todo. Posibilidad de venderlo separado.
Saludos
Adjunto las caracteristicas del ampli :
Power: 200 watts per channel into 8 Ohms. Both channels driven from 20Hz to 20kHz at less than 0.2% total harmonic distortion
Frequency Response: 20Hz to 20kHz ±0.2dB, -3dB at 5Hz and -3dB at 70kHz
Distortion: Typically <0.05% THD at rated power 0.2% THD and IM worst case prior to clipping
Current Output: 40A short duration peak per channel. Fuse protected
Slewing: 50V/µs
Hum & Noise: 90dB below rated ouput 20Hz to 20kHz unweighted
Gain: Line inputs to speaker out: 40dB
Phono Input To Pre-Out: 66dB on high gain, 60dB on low gain
Input Impedance: 47kOhms all inputs
Input Overload: 5V RMS
Rated Pre Out Level: 1.5V RMS into 47kOhms or higher
Pre Out Source Impedance: Typically 1.5k Ohms
Pre Out Minimum Recommended Load: 47kOhms
Tape Output Level: 190mV at 200 Ohms. Tape loop muting at 5V RMS input
Dimensions: Height 120mm (4.75"), Width 450mm (17.75"), Depth 400mm (15.75"), Weight 14kg (30lbs)